MINOLTA-QMS Magicolor 2 Desklaser Specifications download pdf (Page 125)

#$"

(*

.1# '

6 Insert the new SIMM into the SIMM connector.

a Hold the SIMM at a 45° angle to the controller board, with the notch on the

right side and the bottom edge in the connector.

»Note:

You can insert a SIMM in any SIMM connector as long as DRAM and

the SIMM connector before the one you’re installing are occupied.

b Tilt the SIMM up to a 90° angle until you feel it snap into place.

When seated, the SIMM stands upright, firmly in place. If you cannot snap the

SIMM into place, do not force it. Reposition it, making sure that the bottom of

the SIMM is seated completely in the connector.

7 Repeat steps 5–6 for each additional SIMM being installing.

8 Reinstall the controller board into the printer.

Gently slide the controller board into the printer until it is fully seated, and then

tighten the two screws.

9 Reconnect all interface cables.

10 Reconnect the power cord, and turn on the printer.

»Note:

In compliance with UL guidelines, “The appliance inlet is considered to be

the main disconnect device.”

7+3#+-

The system software in your QMS

magicolor

2 DeskLaser is stored in flash ROM,

read-only memory that can be erased and rewritten to “in a flash.” This allows you to

update the system software over the parallel interface without opening up the printer

and installing new PROMs. Updated system software allows you to take advantage of

future enhancements to the printer.

Use this procedure for both Windows 95/98 and Windows NT 4.0 systems:

1 Turn on the PC and the printer.

2 Insert the QMS

magicolor

2 DeskLaser system software disk or CD-ROM in

the appropriate disk drive on your PC.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 275 276

No comments

MINOLTA-QMS Magicolor 2 Desklaser Specifications Page 125