MINOLTA-QMS PagePro 9100 Installation Guide download pdf (Page 24)

Plugging in/Turning on the Printer16

English

Plugging in/Turning on the Printer

Make sure the printer is turned off.

Plug the printer power cord into the

printer and into a dedicated, grounded,

surge-protected electrical outlet.

In compliance with UL

guidelines, “The appliance

inlet is considered to be the

main disconnect device.”

Turn on the printer.

After approximately a 70-second

warmup (assuming normal

temperature and humidity), your

printer prints a startup page and

displays “

IDLE

” on the message

window.

If “

IDLE

” is not displayed in the

message window after the printer is

turned on and warmed up, recheck the setup. If the startup page doesn’t

print or the print quality is not good, skip ahead to “About the Interface

Panel” on page 24.

The printer automatically switches to power-saving (energy-saving) mode

after 30 minutes of inactivity. You can change the number of minutes in the

Administration/Engine/Energy Saver menu.

Attention

Never turn the power off while the printer is receiving data or printing.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 79 80

No comments

MINOLTA-QMS PagePro 9100 Installation Guide Page 24